Download Tecno Spark 4 Air KC1j Stock ROM / Firmware file

Download Tecno Spark 4 Air KC1j Stock ROM / Firmware file from this page and use it to fix all system-related issues like bootloop, corrupted memory and as well as bypass frp and privacy protection. The Tecno Spark 4 Air belongs to the fourth generation of the Spark series

Similar articles

Download Tecno Spark 4 Air KC1j Stock ROM / Firmware file from this page and use it to fix all system-related issues like bootloop, corrupted memory and as well as bypass frp and privacy protection. The Tecno Spark 4 Air belongs to the fourth generation of the Spark series. It continues with the U-shaped notch cut-out display introduced in the flagship Phantom 9 smartphone. It even comes with a single front-facing LED flash just above the screen. The screen itself is a 6.1-inch FullView display with 720 x 1560 pixel resolution. It is powered by a 2.0 GHz MediaTek Helio A22 SoCQuad-Core processor and a 3GB of RAM and 32GB internal storage, expandable up to 128GB via microSD card.

Download the stock firmware for your Tecno Spark 4 Air KC1j form below and follow the instructions provided to flash and fix your bricked device.

Requirements to flash this firmware file

1. Android MTK USBVCOM Drivers
2. SP Flash tool 
3. A Computer
4. A USB cord

Tecno Spark 4 Air KC1j core specifications

1. Model: Spark 4 Air
2. Network: 2G, 3G and 4G Support
3. SIM: Dual SIM
4. Body Dimensions: 156.1 x 75 x 9.2 mm
5. Display Type: IPS Dot Notch Display
6. Display Size: 6.2 inches, 720 x 1560 pixels
7. OS: Android 9 Pie
8. Processor: 2.0 GHz Quad-core Cortex-A7
9. CPU: MediaTek MT6761 Chipset
10. Internal Memory: 32 GB
11. RAM: 2 GB
12. SD Card slot: MicroSD, up to 64GB
13. Primary Camera: 13MP up with Dual LED flash
14. Secondary Camera: 5MP
15. WIFI: Wi-Fi 802.11 b/g/n, Wi-Fi hotspot
16. Bluetooth: Yes
17. GPS: Yes, A-GPS
18. NFC: No
19. USB: MicroUSB v2.0
20. Sensors: G-Sensor, Ambient Light Sensor, Proximity Sensor, Fingerprint
21. Battery Capacity: 3000mAh Li-Polymer battery

How to flash

• Download The stock firmware into your computer and extract it.
• Download SP Flash tool and extract. Also, make sure you have downloaded and installed MTK drivers.
• Now, launch the SP flash tool and load firmware scatter.
• Power off your device, click the download button on the SP flash tool and connect your Tecno Spark Air KC1j.
• The flashing will then start. wait for a couple of minutes and you will see an "OK" when the flashing is completed.

[##cogs## Check out the full flashing guide here]

Download Tecno Spark Air KC1j firmware/ROM

[##download## Tecno KC1j-H6114B-P-190731V141]